You must be logged in to rate content!
2 minute read
997TT Trans Mount Swap in 996TT
Compliments of Mikelly @ www.renntrack.com
So today I put the car up in the air and swapped the factory 2001 tranny mount for the updated 997 model.
Notice the daylight around the upper and lower section of the old mount bushings?
Lack of light on the updated mount bushings.
Old vs. new mount - they look the same, except one has the old "stuff" sprayed on it from the factory, and the replacement is nice/shiney aluminum.
Swapping this mount is cake... You have the two chassis to brace nuts, two tranny mount to tranny bolts, and the black metal brace that has 4 nuts and two bolts. It took me less than 45 minutes to swap the tranny mount on my lift, including removing the bellypans.
Pics of the WEVO motor mount I'm installing below. swapping the black in to replace the blues. Someone asked in another thread, and the 12M bolt required should be 6 inches long.
Mike