By Pseudo_Mechanic
You must be logged in to rate content!
2 minute(s) of a 22 minute read
8-31-2020
9-3-2020
I make a roof panel and tie the front and back of the car together. but most importantly, i use the grinder.
9-7-2020
I build a rear strut tower brace with 1 5/8' mild steel DOM tube and 1/8" 6x6 plates.
9-8-2020
Part 1 of making a new metal skin to merge the c and d pillar
Part 2 of making a metal skin to merge the B and C pillars of the Impreza.
9-11-2020
Part 1 of 4 Videos detailing the finishing fabrication and welding of the rear window opening and c pillar of the wagon to hatchback build.
Comments
This is going to look sick, always wondered why Subaru didn’t make a true hatchback.
Posted by miatamatt on 10/28/20 @ 11:48:40 PM
Man this is a ton of work, lots of chances to show off your skills. I like how you go into each section of the bodywork. You’d think doing something like this would t be too hard but there’s a lot of decisions to make with each panel.
Posted by MPower on 10/31/20 @ 3:07:24 AM