You must be logged in to rate content!
3 minute(s) of a 31 minute read
5-9-2010
Sitting pretty!!
And..... BAM!
Little bit 'o notching for the plenum to fit.
And thanks again Stevo you BA Mofo!
Needs lotsa work but definitely a big leap tonite
5/11/2010
some extra wire deleting done tonight, and thanks to scirocco 75 for the annoyance device Thats what make this community great. Everyone helps everyone.
I like the look, don't knock it or I cut you@!
5/10/2010
ran into a snag. my header after gettin it all wrapped and pretty runs into my rack, i eed to unwrap it all and bend it about 10 degrees. Very lame.
(kinda forgot about the 20mm height increase on the block) Did get the GTI spoiler mounted and the lower subframe and sway bar brackets installed though. Moving along slowly but at least i'm still chugging along.
5/14/2010
well thanks a bunch to henry for coming and helping! Got the motor shimmed forward. The collector is just barely touching the rack mount but at this point could give a shit less. I have the axles installed the usrt smart shift installed, all under vehicle components installed. Now all i need to do is the easy stuff, re-run fuel lines to the passenger side instead of drivers. I am thinking of running nylon lines with quick disconnect for a easy swap fuel filter and ease of installation. Then follow the frame up to the intake area and change to a short rubber section for attaching to the rail. And wire up the megasquirt and figure out a couple coolant lines and sensors and she should be rockin!
Nice project!
Posted by Diggymart on 3/25/20 @ 2:50:35 PM