Project: Drop top vr6 cabby (It Runs) (With Video) by laxman1306

3 minute(s) of a 19 minute read

Clutch fluid tank is done

1/31/12

I've got my gauges in now....just ordered my 42 draft SS crack pipe then I can put coolant in the system and test everything before I pull it apart for body work

9/1/12

These will be the wheels I'm putting on it

Go to working on the car today...I finally broke out the wiring diagrams... I was going through it and found out why my gauges quit working, it was a simple black wire that was unplugged...boom!!! Fixed one less thing to check off

9/6/12

New walbro 255 no need to ever be replaced with this one.

Out with the old burned up Bosch 044

New pump in plenty of pressure now

New fuel regulator

Installed 60psi

Got my gauges working again

Finished gas pedal to be adapted to vr6 cable

Drivers axle is in and fits

Don't mind the shitty welds on the Trans mount those are getting ground off and re-welded with a good welder...the cheap migs are junk from Lowes I've got a Lincoln 220 now

http://s1182.photobucket.com/albums/...t=MVI_0402.mp4