Dougy's S60R by dougy

2 minute(s) of a 189 minute read

then you came to the right place skot53...and i will give you a whopping 10% off...lol

1. cut on the black like.

2. use 3M tape only...unless you like to redo things use a different tape...I dont , so i use 3M ONLY.

3. tape to the boost bracket on the inside...but make sure it is flat with the boost gauge. 

4. test it in place and see if it is flat enough and as you have it pressed against the windshield you will mark the top of your boost gauge and that is where you will place one black rubber dot...(nope it is not felt...it is rubber dot).

5. tape the 3M tape to the bottom and press it in to it's new place.

6. if you ever want to remove it...use thin long knife...and re-tape and put back.

for the IC to throttle body pipe ...you can make your own...if not IPD will be coming out with one soon...so just hold tight...

CAI box

* Jaguar XJ6 canister- gutted, and make 86mm hole on lid of the canister.

* Apexi Power Air Intake Replacement Filter 85mm 160mm ID 500-A021 (eBay) – shave the plastic lip of160mm outer diameter to 157mm which is the dimension of the box on the inside and inner diameter of the filter to 86mm which is the outer dimension of Air mass housing.

7-19-2011

couple more things that I have done since I joined this great forum.