Mercury Mariner / Ford Escape Front Brake Pad and Rotor Replacement

Vehicle: Mercury Mariner/Ford Escape
Time/Difficulty: Simple
Parts Needed:
  • New brake pads and rotors of your choice.
Tools Needed:
  • 19mm socket
  • 18mm socket
  • 7mm allen (or 9mm depending on brake design)
  • ratchet
  • flathead screw driver
  • breaker bar
  • caliper slide pin grease
  • disc brake quiet
  • caliper piston tool (not required, but makes things easier!)
By svalente315
( 4 )

1 minute read

This video explains the process of replacing worn front brake pads and rotors on a 2nd gen Mercury Mariner or Ford Escape. The exact car being worked on is a 2010 Mercury Mariner with the 4cyl engine, but this video should apply to any model within the 2nd generation. I do not take responsibility for any damage you may do to your car. This is meant as a guide for people that already have basic automotive knowledge and maintenance.

Replacing the front pads and rotors is not a difficult process and requires only a few tools, with no expensive specialty tools required. I inspected the rear drums, but they were not worn enough to require replacement at the time.

If you have any questions, comments, or suggestions please leave them below. I will answer every comment to the best of my ability. Thank you for watching!


Comments

Anything new?

Posted by Diggymart on 5/2/23 @ 7:38:41 PM

Great listing parts and tools needed ?

Posted by Diggymart on 1/12/22 @ 8:30:57 PM

Thanks!

Posted by svalente315 on 1/13/22 @ 3:48:45 PM

Thanks for sharing!

Posted by stevegolf on 7/14/19 @ 2:28:22 PM

You got it, glad it was useful!

Posted by svalente315 on 7/16/19 @ 2:06:25 AM