You must be logged in to rate content!
2 minute(s) of a 23 minute read
3-28-2020
8-5-18
-----------------
Ordered a heavy duty springer fork with disk brake adaptor so have to pull the old fork out.
These bearings have to be like 50 years old so I got new ones with new grease.
The stalk is about an inch too long so I cut it down.
Also ran into a problem with the rear sprocket, the inner hole is too small to clear the hub. Thankfully my work has a mini machine shop.
It’s not a well equipped shop so I couldn’t just drill out the hole in one go but it’s better than a dremel.
Next roadblock, the front hub won’t accept the disk, so I’ll either have to replace the hub or get a new wheel.