You must be logged in to rate content!
3 minute read
93-97 MAZDA 626 SHIFT BOOT INSTALLATION INSTRUCTIONS
1. Remove shifter knob. Factory one should just screw off to anti-clockwise toremove.
2. Remove Centre trim Assembly by gently lifting from the rear, Clips should release and allow it to come free. (**NOTE This is easier if shift lever placed in second gear **)
3. When removing centre assembly be aware of the attached wiring loom to the cigarette lighter assembly. This can be removed by a simple depress at the plug assembly of a locking clip.
4. Remove the four screws holding the shift boot ring in place, be careful not to strip the plastic that the screws are fixed too on un-assembly and installation.
5. Remove the shift boot assembly from the surround. Then remove the old shift boot from the plastic support ring and install your new leather shift boot. Take Care that the locating holes are the correct orientation.
6. Install the new shift boot assembly into the plastic surround.
7. Re-install the four screws to secure it in place. Re-assemble the complete centre assembly with the new shift boot assembly in the reverse of the removal procedure.
8. Gently move the boot assembly down over the gear shaft and fold the top edges into the plastic supporting ring. Once this is completed you can re-install the gear shift knob and your task is complete.
ENJOY YOUR NEW LEATHER BOOTS!
Useful tip
You have installed a product made out of genuine leather. As you know, to maintain a leather product in good condition, you should take care of it. We suggest occasionally (every 4-6 week for example) applying some leather conditioner/UV protector to keep your leather from drying up in the sun and cracking.
Redline Automotive Accessories Corp. will not be held liable for any labor, incidental or consequential damages of any kind. Proceed at your own risk.
