By diyauto
You must be logged in to rate content!
2 minute(s) of a 464 minute read
5-5-2010
Here are some photos of the alumacore with the surface prep for laminating and a shot of the new wing end plate profile.
5/6/10
Well, added this to the memory banks of what not to do. Didn't quit get desired finish on the top surface of the splitter. Should have either laid a board on top or made another laminate piece. Needless to say it won't win any appearance contest, but it will get the job done. I did get the desired surface on the bottom though, which is the more important surface.
Also here are the wing end plates. I might be able to salvage the CF finish and clear coat them. They are super light and stiff at least.
Read the Full Article:
http://www.rx7club.com/build-threads-292/afgmoto1978-build-thread-1013041/
Nice build!
Posted by Diggymart on 12/10/19 @ 12:54:14 PM