By diyauto
You must be logged in to rate content!
2 minute(s) of a 464 minute read
2-15-2008
Oil cooler fan in, did a little jerry-rig action at one of the mounting tabs. Next up, weld EGT probe bungs in the headers, remove the stock fuel lines to braze in some -6AN fitting, start laying out the air box, IC arrangement. At first I will be making the air box and ducting out of aluminum, then remake them in CF once I get to that point next month.
2/17/08
EGT bungs in place and re-ceramic coated. The spray can type, not as good as professionally done, but it will still work.
Added a plate the oil injection pump head shield and Bobby wrapped it in the gold stuff. I added this to protect it from the headers.
Read the Full Article:
http://www.rx7club.com/build-threads-292/afgmoto1978-build-thread-1013041/
Nice build!
Posted by Diggymart on 12/10/19 @ 12:54:14 PM