By diyauto
You must be logged in to rate content!
2 minute(s) of a 464 minute read
2-22-2008
Well progress being made, the long task of making an aluminum Airbox and IC end tanks has arrived. Going to seals unlimited today to get some specialty seals.
As discussed by other 500R owner a sacrificial 9/16" wrench is needed in order to tighten one of the nuts.
2/24/08
Slowly but surely. Need to finish the end tanks, weld in the Second BOV flange and start cutting up the 4" tubing for the air box. Will be redoing the end tanks later to clean up the shape.
Read the Full Article:
http://www.rx7club.com/build-threads-292/afgmoto1978-build-thread-1013041/
Nice build!
Posted by Diggymart on 12/10/19 @ 12:54:14 PM