You must be logged in to rate content!
2 minute(s) of a 148 minute read
11-4-2011
Little O-ring big problems... after trying to get the fuel system set up we found the primaries we're leaking... so had to go out and get some bigger o-rings... small difference in size. big difference in no leak!
poor bumper has been sitting for months and has been getting squashed under two other bumpers and tools! put it with 3 bolts just to straighten it out a little... can't wait till its redone and on the car! looking good!
11-14-2011
note to self... need to start wearing gloves while working... this time I slammed my hand against the frame edge pulling the intercooler pipes off! it was not going loose so I pulled hard and BAM it let go and my hand punched the metal! nothing a little shop towel and ziptie can't fix to make a bandaid!
After searching HIGH and LOW for slightly longer engine mount bolt I finally found one! had to use like 6 washers to get it shorter to the length I needed but it got there! (issue was the block is cracked right by the mount screw hole so the threading wont hold... I got it in.
Car is now dropped on the floor and fluids going in! then only need to tighten up loose ends and hope it starts up!
