You must be logged in to rate content!
2 minute(s) of a 122 minute read
8-28-2013
Mid week update. Got the alternator back from B&M and the motor is fully ready to be installed. Dale worked on it some more to finalize it yesterday. Now we just need time to put it in.
Ready for install
DALE is the man....or mad rx-scientist. 
9-2-2013
Update 09/02/13: Dale went over the motor one more time to make sure we were not missing any important stuff, new plugs and wires installed, dropped the motor in, downpipe/exhaust installed (pain), harness installed and buttoned up a few more things before we both ran out of steam. Still have to install Apexi-FC ecu, intercooler, all fluids, intake and start/tune car. Wednesday we may go at it again and hopefully get a few more things crossed off the list. Getting closer.
Finally off the engine stand
New Viton check valves installes
New NGK spark plugs and wires installed.
Ready to drop in
All snuggly and junk
Belts and everything from the Tranny, down pipe, up to the intercooler installed and buttoned up.
Motor in. Front suspension should settle a little more and sit lower.