1st Gen Datsun Z car LSx Swap In-Progress by Ford_Assassin

By diyauto
( 5 )

3 minute(s) of a 10 minute read

10-2-2009


Alright, the car runs and drives for 2 weeks now and no major problems so far. Cam is alittle lopey, but that's cool because I like that sound. The car is a bit loud for my taste so I might add two Dynomax bullet mufflers under the car in the near future.

The power and torque is available EVERYWHERE. Doesn't matter what RPM or speed, it wants to move.

Traction is a serious issue. I thought I had traction issues with BBZ, this car is straight scary at times. Even if I slowly roll into the throttle it will still blow the tires away up until 50+ mph. This is with 245/50/16 tires btw.


12-25-2009

Well I've managed to munch a set of spider gears in the stock R200 so I just welded everything up (poor-man's spool) until funds allow a LSD unit with CV's to replace it. I have also started messing with the bodywork again. Hopefully I'll have a budget paint job on it by June, but time will tell.

I am also have plans in the future to replace the truck intake with a Edelbrock Pro-Flo intake. I have the hood clearance, and its just alittle more $$ than a stock LS6 intake and half the cost of a FAST with greater gains.


1-27-2010

Here is a pic of the same shifter in my last Z car, it was done exactly the same in the current car.

I welded a plate to cover the manual shifter hole, then mounted the shifter to the plate as if it were any ordinary trans tunnel. Same goes for cable routing.



1-28-2010

Thanks for the kind words guys.

This is what the car looks like now:



6-6-2010

Took the car to the track for the first time. I was only able to run once since it was so packed, but it ran a 12.2 @117 mph on my bald street tires (2.2 60ft). Even so, I am pretty sure could of nailed a 11.9 or better with the current setup if I was able to secure more runs. Next on my shopping list is a set of slicks or drag radials. Then maybe a 150 shot of nitrous to get me kicked out for running into the 10's w/o a roll bar.


9-22-2010

Finished yesterday, it was mostly a DIY job. I did most of the bodywork and a buddy sprayed the paint in his shop (no booth). The paint is GM gloss with single stage urethane enamel with House of Kolor custom mixed cobalt blue metallic Rallye style stripes. In a month it'll get cut and buffed to improve minor flaws. Its not show worthy, but good enough for my daily driver and will always be kept clean, garaged, and polished/waxed.






Comments

Loved the Z’s

Posted by Diggymart on 10/10/21 @ 7:30:32 PM