DATSUN Z INSTALLATION INSTRUCTIONS

By diyauto
( 1 )

2 minute read

Shift boot store


DATSUN Z INSTALLATION INSTRUCTIONS


1. First unscrew the shift knob to take the shift boot out. 

2. Unscrew the choke knob and remove.

3. Remove screws from the side of the centre console. 2 sets on each side. One set is up nearer the dash.

4. Remove screws from centre storage compartment.

5. Now raise the centre console.

6. You can see the clips holding the original boot in place. These slide off and you can remove the old boot.

7. Put the new boot in place with the clips and lower centre console. Put screws back and you are done.

 

8. The e-brake boot is easy, simply slide the boot over the brake handle. You will need to buy press studs. These press the square bottom part of the boot onto existing studs in the car.

Useful tip

You have installed a product made out of genuine leather. As you know, to maintain a leather product in good condition, you should take care of it. We suggest occasionally (every 4-6 week for example) applying some leather conditioner/UV protector to keep your leather from drying up in the sun and cracking.

Redline Automotive Accessories Corp. will not be held liable for any labor, incidental or consequential damages of any kind. Proceed at your own risk.

BUY THIS PART HERE!


Comments