SUBARU IMPREZA, CROSSTREK, XV 2017+ shift boot INSTALLATION INSTRUCTIONS

By diyauto
( 1 )

2 minute read

Shift boot store


1. Remove shift knob and shift boot. Shift knob simply unscrews, shift boot can be pulled off - just pull edges of shift boot towards the shifter to disengage the clips holding the bracket to the console. If the clip doesn't give by itself, use a dull tool to push the clip towards the center until they do.

2. After the shift boot has been taken off, you are left with the bezel.

3. Take the new shift boot and align it over the bezel in the correct position and attach the pre-cut holes on the shift boot to the bezel.

4. Once the shift boot has been applied to the shifter bezel, place the completed assembly back into its slot (pressure may be applied to get the clips back in place.) Install shift knob and you are done!


BUY THIS PART HERE!



Comments