My White Hatch‬ by sekang0

4 minute(s) of a 51 minute read

joel23 wrote:

looks good man i like that mishimoto rad and fans may have to pic one up in the future...

Thanks man. It's workin out good so far. 

Went for a drive today to test hose leak. Clamp was a little off before. All good now.

BeanBone wrote:

Sweet build! Does the Mishimoto rub against the Injen?

Yea it does. Had to use a dremel and grind out the inside "pipe stopper" rubber area so I could push the filter in further and clamp it down.

8-15-2013

ElChinoxNJ wrote:

Are you running the hks cams at 0 degrees both or did you time the cams? How do they feel daily driving Im looking to pick up a pair for myself. Thanks!

Should've degreed the cams but didn't. Running at 0 with ~850 rpm idle cuz I have AC/PS. Any lower rpm and there's a bit more shaking of the car left and right than I like from engine shaking (stock ECU). Driving is just like normal and smooth but rev powerband is better higher up and pulls more... if that helps haha.

10-20-2013

Update pics:

Lost my front plate a while back so NEW PLATES.

genuine TRD knob

Thought long and hard about changing the interior... Didn't need to be very practical since its not my daily...

Interior before:

Sold front seats!

Picked up some replica bride gias v2 from member stock4ag. with wedge engineering brackets.

The first "fake" part I've bought...

Makes me sad and happy at the same time. Lot of hate with fake stuff.

I can use them without caring as much about rips/wear down the line was my reasoning.

Better than stock, and pretty sturdy so far.