Aaron's 76 Type LT Project

2 minute(s) of a 383 minute read

Got some more done today. I needed to do a few small, but time consuming, things before I started fitting the 1/4 panel up. When I removed part of the rocker panel I could see lots of debris inside the rocker, including some sand from sand blasting.

So I decided to make a little doorway so I could vacuum out the trash. This area is completely concealed under the 1/4 panel so it was the best spot available.  



You can actually see all the leaves inside the rocker

Door closed up for good



I put the 1/4 panel on just to get the ball rolling. It went on fairly easily, to my surprise. I will work on fitment tomorrow.