You must be logged in to rate content!
5 minute(s) of a 383 minute read
6-6-2015
So I got the top of the hood sprayed with base and clear....again. It went many times better than the first time, so at least I have that going for me. No sweat bombs, no runs and only minor trash to deal with. I went ahead and shot 4 coats of clear to give me some extra wiggle room.
Tomorrow I plan to spray the rest of the remaining pieces and then I can turn my attention to sanding the shell for more clear.![[​IMG]](/uploads/users/3/2017/10/MwEaO2Wl-1507572141.jpg)
![[​IMG]](/uploads/users/3/2017/10/cSRdLOal-1507572141.jpg)
![[​IMG]](/uploads/users/3/2017/10/rhaE8hel-1507572141.jpg)
![[​IMG]](/uploads/users/3/2017/10/7heJ9sYl-1507572141.jpg)
6-7-2015
so I can say that all pieces are officially painted, even though I am re-spraying the shell. This was without a doubt my best spraying session thus far, oddly enough. I hope to keep the momentum going on the shell.
I should only need to do a small amount of sanding on the tops of the bumpers. I doubt I will do anything to the area below the middle bumper strip.![[​IMG]](/uploads/users/3/2017/10/eliHvrSl-1507572141.jpg)
![[​IMG]](/uploads/users/3/2017/10/gw32Gr4l-1507572141.jpg)
![[​IMG]](/uploads/users/3/2017/10/aRgjrPal-1507572141.jpg)
![[​IMG]](/uploads/users/3/2017/10/mXHi4ahl-1507572141.jpg)
![[​IMG]](/uploads/users/3/2017/10/BuuOCczl-1507572141.jpg)
![[​IMG]](/uploads/users/3/2017/10/Ipfizuol-1507572141.jpg)
6-20-2015
I finally got started on sanding the shell in 800 to re-clear next weekend. I have most of the outer panels done so I should be able to get the rest done tomorrow and then I can begin cleaning and re-masking.
After that I can begin the real cutting & buffing stage of the project.![[​IMG]](/uploads/users/3/2017/10/7Puio3fl-1507572141.jpg)
![[​IMG]](/uploads/users/3/2017/10/EMfTEnal-1507572141.jpg)
6-30-2015
I am getting the shell masked off for spraying clear, which I plan on doing this Friday. So nothing too sexy to share at this time.
However, here's a first look at the next member of the household. He was being a little shy so we couldn't get a good look at his face. But everything looked good so that was great news.![[​IMG]](/uploads/users/3/2017/10/yqSPIA4l-1507572141.jpg)
7-1-2015
It's like deja vu all over again....I have the shell ready for round 2 of clear. I need to do some minor color touch up tomorrow and then will spray clear on Friday morning. That will give me 3+ days to do some sanding in preparation for buffing. I should be able to do some serious sanding in that time.
I masked off several areas I was happy with and didn't want to re-clear. The biggest mistake I made the first time around was not spraying color along the very bottom of the rear tail, so I left that exposed so I could address it.![[​IMG]](/uploads/users/3/2017/10/Inw73A5l-1507572141.jpg)
![[​IMG]](/uploads/users/3/2017/10/nRYGsZol-1507572142.jpg)
![[​IMG]](/uploads/users/3/2017/10/KgXo5pel-1507572142.jpg)
7-3-2015
Got the shell re-cleared. I took her out in the sun to enjoy the heat a little.![[​IMG]](/uploads/users/3/2017/10/7daS45ll-1507572142.jpg)
![[​IMG]](/uploads/users/3/2017/10/IrkcFMxl-1507572142.jpg)
![[​IMG]](/uploads/users/3/2017/10/QDw97WYl-1507572142.jpg)
![[​IMG]](/uploads/users/3/2017/10/WYIqQZJl-1507572142.jpg)
![[​IMG]](/uploads/users/3/2017/10/DagwQyYl-1507572142.jpg)
![[​IMG]](/uploads/users/3/2017/10/nkmritSl-1507572142.jpg)
![[​IMG]](/uploads/users/3/2017/10/rr0re4Al-1507572142.jpg)
This is cool ?
Posted by Diggymart on 1/27/21 @ 4:16:49 PM