My 998 Turbo by coopdog

2 minute(s) of a 43 minute read

right so the engine for now is going to be a
Fully strip down and rebuild so i know it will take the turbo and be running to the best of its ability, becuase nbow it is very rough and down on power


28/36 Weber Carb
RC40 1.75" Exhaust
LCB Manifold
Stage 3 12G295 Head
998+40 Making it a 1030cc
MG Metro Cam
X Pin Diff
Centre Oil Pickup

so hope fully that will give a nice 60 Bhp that will keep me happyfor know as i think the engine currently has like 34 or something low :L

so when i strip it down is there anything i should replace?
i will buy a full new gasket set
cam followers

not sure about the rest :/
new cam timing things, duplex?
any help would be amazing :)

3-10-2012

just got my manifold for a 28/36 weber

3-12-2012

went and got the carb which has been sitting under the reception desk of my familys window making bussines for like 25years :L


also i cleaned up the manifold and found a crack
so i will send this to be repaired :)
should i try and get someon money back off the person who sold it to me because they said it was fine?

will post some high quality ones after :)

3-17-2012

thats off the list now :)
this is what i have now :)
AEG584 - CAM FOLLOWER WITH OIL HOLE,MINIPARES CHILLED ...

GLP139 - OIL PUMP 1000CC A PLUS SLOT DRIVE

AJM202MS - BLOCK GASKET SET SMALL BORE PLUS COOPER S

AJM1250 - SMALL BORE COPPER HEAD GASKET SET 850/998/110...

AJM804B - GEARBOX GASKET SET

C-AJJ3385 - MINISPARES MOLYBDENUM CROSS PIN DIFF

C-AHT54 - OIL PIPE HITECH CENTRAL PICKUP GEARBOX

GFE166 - OIL FILTER SPIN ON TYPE 1973 to 1996 (GFE443)

GAP413 - YELLOW ENGINE SPRAY (AEROSOL NOT TO BE SENT ...

got to get some engine mounts but i want ones that wont give me any problem :/ how are the ones from huddersfield?
and i dont want to use minisport :L

anything else?