My 89 MI16

2 minute(s) of a 84 minute read

I had to remove IM for wire harness test fit and I added new vacuum fittings on the bottom of IM. Also I made coil pack bracket and found new home for ignitior,resistor pack and purge valve.

11-19-2014

Black dash and interior is finally finished. I ordered lower roller bearing and shim kit for coilover springs and new camber plates.

Here is picture of 2g DSM roller mount installed in XU9J4 roll engine bracket. Also ECMlink swap is 70% done.

I'm happy with results. I also ordered one for my Wagon.

11-23-2014

IM,EVO 560's injectors,2g DSM rail and 1g NT TB is permanently mounted.

OBD II diagnostic port is actually mounted pointing down just like on any OBD II vehicles.

Injector pack and coils are mounted on battery tray.

I drilled and tapped 2g DSMcoolant temp sensor is same location where Bosch one was before.