You must be logged in to rate content!
2 minute(s) of a 77 minute read
4-15-2016
Next Step was plumbing up all my air lines and fittings.
My first job was to figure out how to run all of the air fittings I needed for my Lockers, tire fill chuck, pressure safety release, and my pressure on/off valve. Since my air tank only had 4 ports total I decided I needed to go with an air manifold of some sort. Nothing I found on line seamed to be able to mount anywhere I needed. So in stead I decided to fab up my own in a buddies machining shop.
Started with a 2x6" piece of aluminum and went from there
Quite a few hours later!
I mounted that near my air filter box and then ran my ARB solenoids and air lines to my tank and the manifold.
Do to the nature of the York Compressors and the oil out put they tend to spew I added in a coalescing filter to seperate the oil and any water out.
Great build!
Posted by Diggymart on 3/5/21 @ 3:45:02 AM