97 TJ Heep to Zombie Killing Jeep Build by north50

2 minute(s) of a 286 minute read

Fit the 03'-06' radio and bezel and it looks great, just need a switch panel for the bottom. 

Almost finished with the jeep, had to pickup a 9/16 drill bit today to install the JKS trackbar then I'm done. Backed it out of the garage so I could straighten up the garage and put my wife's mustang back in.

3-26-2011

So I finally got the 9/16 hole drilled for the new bolt included in the JKS front track bar. have it mounted and according to my measurements the axle is centered. Also bolted up the new steering stabilizer and took it for a spin around the block. Alot of vibration even at very low speeds so back into the garage to put the transfer case drop kit on and the JKS 1.25" BL and 1" MML. I did finish the front brakes and put helper bleeders in the new calipers, made it a breeze to bleed the air out and a firm pedal. New problems are engine light came on (will take it to be scanned as soon as I finish the transfer case drop) and the A/C won't kick on. Compressor doesn't do anything but spins by hand. So now that it is 90 degrees and I put a hardtop on the A/C is acting up

Looking into building some sort of hoist/lift to store the hardtop and still haven't had any luck finding full doorsfor reasonable. I did order this today.

http://www.quadratec.com/products/12526_1X_PG.htm

Plenty to do tomorrow, just hope I have time to do it.