Motion Raceworks S10 1st Gen (Square Body) Drag Wing Install

By diyauto

Not yet rated

1 minute read

Motion Raceworks 1st Gen S10 Drag Wing

This 100% Made In the USA drag wing is now available at Motion Raceworks by clicking the link below. Easily installed in an afternoon, comes complete with all pieces and hardware. This wing clears a Motion Raceworks parachute mount.

Tools needed for the job:
Hand Drill
#11 or 3/16 drill bit
1/8 allen wrench
3/32 Allen wrench
11/32 socket or wrench
3/8 socket or wrench
Rivet gun
Masking tape