You must be logged in to rate content!
3 minute(s) of a 209 minute read
3-20-2013
whenever you're ready. i can always start over on another FD. i want a different color anyway 
last nite i didn't do too much. i was going to begin putting down more material and when i went out i was quickly reminded that i had some holes to patch before the next section goes down on the driver side.
in this pic you can see three holes in the floor and firewall from the previous owner. this is where he ran the power wire through. i'm not too sure why there's three but, last nite i went ahead and patched the holes. i may snap a pic before i begin putting the rest of the material down but, if i don't, you've all seen a few holes welded up i'm sure.
thanks for the comments guys. they give me inspriation to keep up the work.
3-23-2013
decided to get out in the garage tonite and make alittle progress.
figured i'd try and keep the rows even. once i get alittle further i'm hoping i can use a large sheet to go from side to side.
trying to leave a few plugs open so i can run wire if i have to. there are a few others along the floor and sides and i'm wondering if i should leave those open or just cover them. i'm not really sure i'd ever use any of those. has anyone ever had any use for any of the holes other than the ones in the firewall?
this is where i stopped for the nite. next time i get at it i'm not stopping until i'm past the curved part of the floor. maybe i'll even get the rest of the floor done and be able to start with the rear storage bin area.