You must be logged in to rate content!
8 minute(s) of a 266 minute read
1-6-2013
get ready for the pictures
welding in the new floor
putting on the doorstep which i had to modify to line up right as the cheap panel was way out of shape so i cut a slit down the step which i then ran back up and down with the cutter making a slightly larger slit which i continued to increase until i could push the sill back enough where it would line up i then held it in that position and tacked it in place once welded ground down and filled i lined up beautifully
here i cut pieces of metal out section by section the angle on the cut and the angle of the bend where far too hard for me to get right in the vice
new tool roloc disc grinder p36 grit
there was a gap between the floor and door post that had been cut out because it was rotten so i welded it up
still needs more grinding down
still needs sanding abit more
old welder in the background