TSP Rumbler. Update w/ Part #'s by WarShrike

By diyauto
( 1 )

2 minute read

TSP Rumbler. Update w/ Part #'s 


Compliments of WarShrike @ fullthrottlev6.com


12-22-2008

Just an FYI. Be sure that you have an LS1 f-body exhaust bracket installed. The rumbler is designed to work w/ that bracket. I couldn't wait for that part to get in, so I used the stock V6 bracket. It will hang low and touch the PHB support, causing the vibration to go to the heat shield for the gas tank. Therefore, you will have a horrid vibration at idle that is just annoying.

LS1 bracket is installed, tucket the exhaust up nice and tight and no longer vibrating on the PHB. I think it pulled it up a good inch or so.

Matt from TSP told me of the bracket, but I just didn't have time to get it first.
__________________________________________________ ___________


*UPTADE!*
LS1 F-body exhaust bracket part numbers:
GM# 10275709 Hanger
GM# 10272958 Bracket

This goes on the pass side just after the axle. It has a rubber isolator that is part of the bracket, not just hanging down, letting the exhaust sway to and fro

They are parts 13 & 14 in the attachment.



Comments