EVOMS 775 997.1 TT build by bonehead

By diyauto
( 3 )

5 minute(s) of a 40 minute read

11-5-2010

EVOMS 775 997.1 TT build


Compliments of bonehead @ www.6speedonline.com


11-5-2010

Well, I've had this beauty for almost a year and half and have enjoyed every single minute of it (well, except for that Bilstein fiasco...but I digress...). I've managed to keep her stock power-wise, always wondering what a little more power to an already phenomenal car would be like....well....I'm going full monte. Car is in the hands of the EVOMS crew in Tempe to get some 'tweaks'. Contacted Ian with the original intention of getting the 650 kit. Somehow, I was convinced to invest in the 700/720R kit......wait a sec....775? What the?!!?!?(yes, Ian, I truly hate you)

The 700/720R kit includes
-EVOMSit ECU Chip Switch - Utilizes "On The Fly Switching" with 2 X EPROMS
-EVOMS / SRE Stage 3 Clutch
-EVOMS High Flow VTG Turbochargers w/ Billet Compressor Wheels
-EVOMS ClubSport 44.5mm Exhaust Headers
-EVOMS ClubSport Intercoolers (charge coolers) w/ Silicone Boost Hoses
-EVOMS High Flow Silicone Turbocharger Air Inlet Ducts
-EVOMS Billet Turbocharger Boost Recirculation Valves
-Gaskets, Hardware & Installation Components

I already have a BBI Stage III exhaust with 200 cell cats which I plan on keeping. I may lose a touch of power running the cats, but I'm sure I won't notice.

The 775 upgrade includes

EVOMS ClubSport High Flow Silicone Turbo Air Inlet Ducts
EVOMS ClubSport HED Ignition Coils w/ Denso Platinum Spark Plugs
Bosch 83mm Throttle Body with Larger Intake Plenum
EVOMS Lightweight Billet Underdrive Crank Pulley
EVOMS EVT775 Software Calibration with Optional Dual Mode Chip Switch*
Porsche / EVOMS Vacuum Line Update Kit
Porsche Fuel Filter

In addition, getting stainless steel brake lines and a desperately needed brake fluid flush for more stopping power as well as the the GT2 slave cylinder conversion, which I have been waffling over for the last year. Trans is coming out anyway...so, I thought what the heck

Aside from the BBI Stage III exhaust, power is stock...for now.

Some pics from the shop

Coming off the dyno for a baseline run




On the lift




Baseline dyno (she's a strong one)




Baseline dyno




Either myself, or perhaps Ian, can keep the thread updated with the progress. Hope to get her back later this month....perfect temps in the desert for low IAT's


11-7-2010


Naughty bits






IPD Competition Plenum with GT3 TB's arrive




Clubsport IC's






Stock Turbos




Exhaust off







11-8-2010


Front steel brake lines installed for better stopping power




Rear brake lines




Preparing to install the IPD competition plenum/GT3 throttle bodies




GT2 Slave, SRE Stage 3 clutch and transmission installed





Comments