Phoenix Estate Vvc K-Series Diy Subframe Conversion

2 minute(s) of a 66 minute read

Still not pretty but at least the bits are actually welded together now.

Got 99% of the prep done for finishing the steering rack job.
Dusty!

6-29-2014

Rather annoyingly I ran out of polyester resin about 1/3 of the way though the steering rack job, so I'll have to sand what I did today and start over when I've got some more.

I did manage to get mgf gear linkage off, which is a bugger, because the cable bracket gets in the way of the roll pin, and the linkage part stops you putting a socket on the nut that, in my case, the spanner rounded off!
Anyway, the rover 200 pg1 linkage fits past the subframe revisions, so that's good.

7-2-2014

Slightly better pg1 linkage shot. I have no idea what car this linkage came from? Rover 25?

7-28-2014

A messy job, but steering rack job is glassed in on the bulkhead side now.