AFGMOTO1978 Build Thread by afgmoto1978

5 minute(s) of a 464 minute read

Finally got my 1000cc secondary injectors, need to make new mounting tabs for the rail to seat the injectors better into the LIM.

Expect my primaries to be clean and ready to go today and I will be getting my BBK!

7-26-2007

Big Brake Kit in now, had to modify a few things, but that was to be expected. Finally got all my injectors, should have the motor in the engine bay later this week. After looking into it, I will be add an FJO low impedence fuel injector controller to the mix for proper fuel control. 

7/27/07

Modified my Nardi steering wheel to accept the cruise control switch module and installed the wheel on the steering column. 

7-30-2007

Motor and tranny are in; secondary fuel rail fits, but is a bit tight with the Marren fuel dampener in place and the synapse bov may not work at the secondary boost control setup because of clearances. Will have to see when everything is in place. Rear brakes are also done, had to sand off material on the pads in order to fit. I had this same issue with my stock brakes and HP+ pads.....

And the dash is being repaired, the back lip of the center speaker pod was peeling up. 

8-8-2007

I modified the oil thermostat to include a section for an oil temp sensor; I did this to eliminate the giant cluster F$%K the Mocal temp sensor adapter would have caused. Just need to fab up a rubber isolated mount to the sway bar mount stiffening bar and oil lines can then be routed.

I also removed all the old pealing top coat on my 93 center console and re-textured it to look and kinda feel like a 94 unit.