By diyauto
You must be logged in to rate content!
2 minute(s) of a 237 minute read
11-21-2012
I ultimately went single turbo and a different ducting setup. But in aluminum at this time.
The top of the EDFC stepper motor is roughly 50mm measured at the top most flat surface on the rear shock tower. As far as teins function, they're a pretty good bang for the buck coil-over. Hand they've held pretty good.
Photo from an earlier post, missed a symbol.
12-26-2007
The car is being prepped for the 500R that will be coming soon. Need to modify and remove redundant vacuum line and control valves. Also received new primary injectors and will be installing soon. Efini's gave up the ghost after one to many 17psi pulls.
Read the Full Article:
http://www.rx7club.com/build-threads-292/afgmoto1978-build-thread-1013041/
Nice build!
Posted by Diggymart on 12/10/19 @ 12:54:14 PM